Problems with S.M.A.R.T (OMV - Short self-test on /dev/nvme0n1)

[NicolaiW]

Hello everyone, for some time now, Open Media Vault has been sending me the following error message:

This message was generated by the smartd daemon running on:

host name: omv-nas
DNS domain: local

The following warning/error was logged by the smartd daemon:

Device: /dev/disk/by-id/nvme-CT4000P3SSD8_2342E88107D9, number of Error Log entries increased from 9 to 10

Device info:
CT4000P3SSD8, S/N:2342E88107D9, FW:P9CR30A, NSID:1

For details see host's SYSLOG.

You can also use the smartctl utility for further investigation.
The original message about this issue was sent at Mon Feb 10 14:32:12 2025 CET
Another message will be sent in 24 hours if the problem persists.

When I try to run a "Short self-test" on the "/dev/nvme0n1" manually, omv outputs the following:

smartctl 7.3 2022-02-28 r5338 [x86_64-linux-6.12.9+bpo-amd64] (local build)
Copyright (C) 2002-22, Bruce Allen, Christian Franke, http://www.smartmontools.org

=== START OF INFORMATION SECTION ===
Model Number: CT4000P3SSD8
Serial Number: 2342E88107D9
Firmware Version: P9CR30A
PCI Vendor/Subsystem ID: 0xc0a9
IEEE OUI Identifier: 0x00a075
Controller ID: 1
NVMe Version: 1.4
Number of Namespaces: 1
Namespace 1 Size/Capacity: 4,000,787,030,016 [4.00 TB]
Namespace 1 Formatted LBA Size: 512
Namespace 1 IEEE EUI-64: 6479a7 8440000039
Local Time is: Tue Feb 18 15:25:34 2025 CET
Firmware Updates (0x12): 1 Slot, no Reset required
Optional Admin Commands (0x0017): Security Format Frmw_DL Self_Test
Optional NVM Commands (0x005e): Wr_Unc DS_Mngmt Wr_Zero Sav/Sel_Feat Timestmp
Log Page Attributes (0x06): Cmd_Eff_Lg Ext_Get_Lg
Maximum Data Transfer Size: 64 Pages
Warning Comp. Temp. Threshold: 85 Celsius
Critical Comp. Temp. Threshold: 95 Celsius

Supported Power States
St Op Max Active Idle RL RT WL WT Ent_Lat Ex_Lat
0 + 6.00W 0.0000W - 0 0 0 0 0 0
1 + 3.00W 0.0000W - 0 0 0 0 0 0
2 + 1.50W 0.0000W - 0 0 0 0 0 0
3 - 0.0250W 0.0000W - 3 3 3 3 5000 1900
4 - 0.0030W - - 4 4 4 4 13000 100000

Supported LBA Sizes (NSID 0x1)
Id Fmt Data Metadt Rel_Perf
0 + 512 0 1
1 - 4096 0 0

=== START OF SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED

SMART/Health Information (NVMe Log 0x02)
Critical Warning: 0x00
Temperature: 41 Celsius
Available Spare: 100%
Available Spare Threshold: 5%
Percentage Used: 0%
Data Units Read: 209,028 [107 GB]
Data Units Written: 340,472 [174 GB]
Host Read Commands: 535,891
Host Write Commands: 705,317
Controller Busy Time: 10
Power Cycles: 7
Power On Hours: 190
Unsafe Shutdowns: 0
Media and Data Integrity Errors: 0
Error Information Log Entries: 10
Warning Comp. Temperature Time: 0
Critical Comp. Temperature Time: 0
Temperature Sensor 1: 41 Celsius
Temperature Sensor 2: 57 Celsius
Temperature Sensor 8: 41 Celsius

Error Information (NVMe Log 0x01, 16 of 16 entries)
Num ErrCount SQId CmdId Status PELoc LBA NSID VS
0 10 0 0x4010 0x4005 0x028 0 0 -

Everything works perfectly with the SSD hard drive.

I'm still a bit of a newbie on this topic and would really appreciate some help with this problem.

[Christian Franke]

The 0x4005 in the Status column of the Error Information indicates Invalid Field in Command which could be safely ignored. This is already addressed in smartmontools 7.4, see ticket #1222 for details.

If possible, please update to smartmontools 7.4. Then the error message should no longer occur in these cases.

[Christian Franke]

Already fixed in smartmontools 7.4, see ticket #1222.

[NicolaiW]

Thank you for your answer, Christian.

According to OMV, the system is up-to-date even if I enable “Pre-release updates” and “Community-maintained updates”.

Do I have to update the system with apt?

Best regards, Nicolai

[NicolaiW]

Okay, it seems that smartmontools 7.4 is not yet implemented in Debian Bookworm.

[Christian Franke]

7.4 is available in bookworm-backports: ​https://packages.debian.org/bookworm-backports/smartmontools