== >> Fujitsu Devices << ==

=== Interpretation of S.M.A.R.T. Attributes ===
|| '''Device Model''' || '''Attributes ID#''' || '''Attributes Name''' || '''Special''' || '''Description''' ||
||   || 1 || Raw Read Error Rate || || Frequency of errors while reading raw data from a disk. ||
||   || 2 || Throughput Performance || || Average efficiency of a hard disk. ||
||   || 3 || Spin Up Time || || Time needed by spindle to spin-up. ||
||   || 4 || Start/Stop Count || || Number of start/stop cycles of spindle. ||
||   || 5 || Reallocated Sector Count || || Quantity of remapped sectors. ||
||   || 6 || Start/Stop Count || || Number of start/stop cycles of spindle. ||
||   || 7 || Seek Error Rate || || Frequency of errors appearance while positioning. ||
||   || 8 || Seek Time Performance || || The average efficiency of operations while positioning. ||
||   || '''9''' || '''Power-On Hours Count''' || (!) || Quantity of elapsed hours in the switched-on state. ||
|| not all (which?) ||   ||||||  ''Some models of Fujitsu disks use Attribute 9 to store the power-on disk lifetime in seconds. In that case, use the: {{'-v 9,seconds'}} option to correctly display hours, minutes and seconds.'' ||
||   || 10 || Spin-up Retry Count || || Number of retry attempts, that were needed to reach the operational speed of the spindle. ||
||   || 11 || Calibration Retry Count || || Number of attempts to calibrate a drive. ||
||   || 12 || Power Cycle Count || || Number of complete power on/off cycles of hard disk. ||
||   || 13 || Soft Read Error Rate || || Frequency of program errors appearance while reading data from a disk. ||
||   || 192 || Power-Off Retract Cycle || || Emergency Retract Cycle Count ||
||   || 193 || Load/Unload Cycle Count || || Number of cycles into Landing Zone position. ||
|| not all (which?) || 194 || HDA Temperature || || Temperature of a Hard Disk Assembly. ||
||   || 195 || Hardware ECC Recovered || || ECC On The Fly Count ||
|| not all (which?) || 196 || Reallocated Event Count || || Number of remap operations. That means replacing a bad sector by one from the spare area. ||
||   || 197 || Current Pending Sector Count || || Current number of unstable sectors (waiting for remapping). ||
||   || 198 || Offline Scan Uncorrectable Count || || Number of uncorrected errors. ||
|| not all (which?) || 199 || UltraDMA CRC Error Rate || || Total number of errors CRC during UltraDMA mode. ||
|| ''<unknown>'' || 200 || Write Error Rate || || Number of errors while writing to disk (or) flying height (?) (Western Digital: Multi Zone Error Rate). ||
|| ''<unknown>'' || 201 || Soft Read Error Rate || || Frequency of program errors appearance while reading data from a disk. ||
|| ''<unknown>'' || 202 || Data Address Mark Errors || || Number of Data Address Mark (DAM) errors (or) vendor-specific. ||
|| ''<unknown>'' || 203 || Run Out Cancel || || Number of the ECC errors (Maxtor: ECC Errors). ||
|| ''<unknown>'' || 204 || Soft ECC Correction || || Quantity of errors corrected by software ECC. ||
|| ''<unknown>'' || 205 || Thermal Asperity Rate (TAR) || || Frequency of the thermal asperity errors. ||
|| ''<unknown>'' || 206 || Flying Height || || The height of the disk heads above the disk surface. ||
|| ''<unknown>'' || 207 || Spin High Current || || Amount of high current used to spin up the drive. ||
|| ''<unknown>'' || 208 || Spin Buzz || || Number of buzz routines to spin up the drive. ||
|| ''<unknown>'' || 209 || Offline Seek Performance || || Drive's seek performance during offline operations. (Relation to Seek Time Performance - #8?) ||
|| ''<unknown>'' || 220 || Disk Shift || || Shift of disk is possible as a result of strong shock loading in the store, as a result of it's falling or for other reasons (sometimes: Temperature) ||
|| ''<unknown>'' || 221 || G-Sense Error Rate || || Frequency of mistakes as a result of impact loads as detected by a shock sensor(?). ||
|| ''<unknown>'' || 222 || Loaded Hours || || Number of hours in general operational state. ||
|| ''<unknown>'' || 223 || Load/Unload Retry Count || || Loading on drive caused by numerous recurrences of operations, like reading, recording, positioning of heads, etc. ||
|| ''<unknown>'' || 224 || Load Friction || || Load on drive caused by friction in mechanical parts of the store. ||
|| ''<unknown>'' || 225 || Load/Unload Cycle Count || || Number of cycles into Landing Zone position. ||
|| ''<unknown>'' || 226 || Load-in Time || || General time of loading for drive. ||
|| ''<unknown>'' || 227 || Torque Amplification Count || || Quantity efforts of the rotating moment of a drive. ||
|| ''<unknown>'' || 228 || Power-Off Retract Cycle || || Number of power-off cycles (Fujitsu: Emergency Retract Cycle Count). ||
|| ''<unknown>'' || 230 || GMR Head Amplitude || || Amplitude of heads trembling (GMR-head) in running mode. ||
|| ''<unknown>'' || 231 || Temperature || || Temperature of a drive. ||
|| ''<unknown>'' || 240 || Head Flying Hours || || Time while head is positioning. ||
|| ''<unknown>'' || 250 || Read Error Retry Rate || || Number of errors while reading from a disk. ||

'''References:''' http://www.ariolic.com/activesmart/smart-attributes/