Seagate ST8000NM0075 unsupported

[Joseph Wu]

It appears that the Seagate ST8000NM0075 behind a LSI 9300-8i running FW P10 doesn't display much SMART information.

Running command: smartctl -t short /dev/da0

smartctl 6.4 2015-06-04 r4109 [FreeBSD 10.3-RELEASE amd64] (local build)
Copyright (C) 2002-15, Bruce Allen, Christian Franke, www.smartmontools.org

Short Background Self Test has begun
Use smartctl -X to abort test

Works just fine... but.. smartctl -a shows:

smartctl 6.4 2015-06-04 r4109 [FreeBSD 10.3-RELEASE amd64] (local build)
Copyright (C) 2002-15, Bruce Allen, Christian Franke, www.smartmontools.org

=== START OF INFORMATION SECTION ===
Vendor:               SEAGATE
Product:              ST8000NM0075
Revision:             E001
Compliance:           SPC-4
User Capacity:        8,001,563,222,016 bytes [8.00 TB]
Logical block size:   512 bytes
Physical block size:  4096 bytes
LB provisioning type: unreported, LBPME=0, LBPRZ=0
Rotation Rate:        7200 rpm
Form Factor:          3.5 inches
Logical Unit id:      0x5000c50XXXXXXXX
Serial number:        ZA10XXXXXXXXXXXXX
Device type:          disk
Transport protocol:   SAS (SPL-3)
Local Time is:        Tue Mar 29 20:57:14 2016 PDT
SMART support is:     Available - device has SMART capability.
SMART support is:     Enabled
Temperature Warning:  Enabled

=== START OF READ SMART DATA SECTION ===
SMART Health Status: OK

Elements in grown defect list: 0

Error Counter logging not supported

Device does not support Self Test logging