Opened 4 years ago
Last modified 3 years ago
#1433 closed enhancement
WDC-WD141KRYZ-01C66B0 - req. to add 14tb wd (hgst) helium gold drive to database — at Initial Version
Reported by: | Mick Russom | Owned by: | |
---|---|---|---|
Priority: | minor | Milestone: | Release 7.3 |
Component: | drivedb | Version: | |
Keywords: | hdd | Cc: |
Description
WDC-WD141KRYZ-01C66B0
Request to add this to the drivedb.
inline ====
smartctl 7.1 2019-12-30 r5022 [x86_64-linux-5.4.0-58-generic] (local build)
Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org
START OF INFORMATION SECTION
Device Model: WDC WD141KRYZ-01C66B0
Serial Number: 00000000
LU WWN Device Id: 5 000000 000000000
Firmware Version: 01.01H01
User Capacity: 14,000,519,643,136 bytes [14.0 TB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Rotation Rate: 7200 rpm
Form Factor: 3.5 inches
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: ACS-2, ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 3.2, 6.0 Gb/s (current: 3.0 Gb/s)
Local Time is: Sat Jan 23 20:31:10 2021 UTC
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
AAM feature is: Unavailable
APM level is: 254 (maximum performance)
Rd look-ahead is: Enabled
Write cache is: Enabled
DSN feature is: Unavailable
ATA Security is: Disabled, frozen [SEC2]
Wt Cache Reorder: Enabled
START OF READ SMART DATA SECTION
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 248) Self-test routine in progress...
80% of test remaining.
Total time to complete Offline
data collection: ( 101) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: (1447) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE
1 Raw_Read_Error_Rate PO-R-- 100 100 001 - 0
2 Throughput_Performance P-S--- 138 138 054 - 96
3 Spin_Up_Time POS--- 083 083 001 - 325 (Average 355)
4 Start_Stop_Count -O--C- 100 100 000 - 27
5 Reallocated_Sector_Ct PO--CK 100 100 001 - 0
7 Seek_Error_Rate PO-R-- 100 100 001 - 0
8 Seek_Time_Performance P-S--- 133 133 020 - 18
9 Power_On_Hours -O--C- 100 100 000 - 757
10 Spin_Retry_Count PO--C- 100 100 001 - 0
12 Power_Cycle_Count -O--CK 100 100 000 - 27
22 Unknown_Attribute PO---K 100 100 025 - 100
192 Power-Off_Retract_Count -O--CK 100 100 000 - 44
193 Load_Cycle_Count -O--C- 100 100 000 - 44
194 Temperature_Celsius -O---- 059 059 000 - 35 (Min/Max 23/41)
196 Reallocated_Event_Count -O--CK 100 100 000 - 0
197 Current_Pending_Sector -O---K 100 100 000 - 0
198 Offline_Uncorrectable ---R-- 100 100 000 - 0
199 UDMA_CRC_Error_Count -O-R-- 100 100 000 - 0
_ K auto-keep | C event count _ R error rate | S speed/performance _ O updated online | P prefailure warning
General Purpose Log Directory Version 1
SMART Log Directory Version 1 [multi-sector log support]
Address Access R/W Size Description
0x00 GPL,SL R/O 1 Log Directory
0x01 SL R/O 1 Summary SMART error log
0x02 SL R/O 1 Comprehensive SMART error log
0x03 GPL R/O 1 Ext. Comprehensive SMART error log
0x04 GPL R/O 256 Device Statistics log
0x04 SL R/O 255 Device Statistics log
0x06 SL R/O 1 SMART self-test log
0x07 GPL R/O 1 Extended self-test log
0x08 GPL R/O 2 Power Conditions log
0x09 SL R/W 1 Selective self-test log
0x0c GPL R/O 5501 Pending Defects log
0x10 GPL R/O 1 NCQ Command Error log
0x11 GPL R/O 1 SATA Phy Event Counters log
0x12 GPL R/O 1 SATA NCQ Non-Data log
0x13 GPL R/O 1 SATA NCQ Send and Receive log
0x15 GPL R/W 1 Rebuild Assist log
0x21 GPL R/O 1 Write stream error log
0x22 GPL R/O 1 Read stream error log
0x24 GPL R/O 256 Current Device Internal Status Data log
0x25 GPL R/O 256 Saved Device Internal Status Data log
0x2f GPL - 1 Set Sector Configuration
0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log
0x80-0x9f GPL,SL R/W 16 Host vendor specific log
0xe0 GPL,SL R/W 1 SCT Command/Status
0xe1 GPL,SL R/W 1 SCT Data Transfer
SMART Extended Comprehensive Error Log Version: 1 (1 sectors)
No Errors Logged
SMART Extended Self-test Log Version: 1 (1 sectors)
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 755 -
# 2 Short offline Completed without error 00% 245 -
# 3 Short offline Completed without error 00% 224 -
# 4 Extended offline Completed without error 00% 223 -
# 5 Extended captive Interrupted (host reset) 90% 199 -
# 6 Short captive Interrupted (host reset) 50% 199 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
SCT Status Version: 3
SCT Version (vendor specific): 256 (0x0100)
Device State: DST executing in background (3)
Current Temperature: 35 Celsius
Power Cycle Min/Max Temperature: 32/37 Celsius
Lifetime Min/Max Temperature: 23/41 Celsius
Under/Over Temperature Limit Count: 0/0
SMART Status: 0xc24f (PASSED)
Minimum supported ERC Time Limit: 65 (6.5 seconds)
SCT Temperature History Version: 2
Temperature Sampling Period: 1 minute
Temperature Logging Interval: 1 minute
Min/Max recommended Temperature: 0/60 Celsius
Min/Max Temperature Limit: -40/70 Celsius
Temperature History Size (Index): 128 (79)
Index Estimated Time Temperature Celsius
80 2021-01-23 18:24 33
... ..( 7 skipped). ..
88 2021-01-23 18:32 33
89 2021-01-23 18:33 34 *
... ..( 31 skipped). .. *
121 2021-01-23 19:05 34 *
122 2021-01-23 19:06 35
123 2021-01-23 19:07 34 *
124 2021-01-23 19:08 34 *
125 2021-01-23 19:09 35
126 2021-01-23 19:10 34 *
127 2021-01-23 19:11 34 *
0 2021-01-23 19:12 35
1 2021-01-23 19:13 35
2 2021-01-23 19:14 34 *
... ..( 3 skipped). .. *
6 2021-01-23 19:18 34 *
7 2021-01-23 19:19 35
8 2021-01-23 19:20 35
9 2021-01-23 19:21 34 *
10 2021-01-23 19:22 35
11 2021-01-23 19:23 34 *
... ..( 2 skipped). .. *
14 2021-01-23 19:26 34 *
15 2021-01-23 19:27 35
... ..( 62 skipped). ..
78 2021-01-23 20:30 35
79 2021-01-23 20:31 33
SCT Error Recovery Control:
Read: Disabled
Write: Disabled
Device Statistics (GP Log 0x04)
Page Offset Size Value Flags Description
0x01 ===== = = === == General Statistics (rev 1) ==
0x01 0x008 4 27 --- Lifetime Power-On Resets
0x01 0x010 4 757 --- Power-on Hours
0x01 0x018 6 248378002069 --- Logical Sectors Written
0x01 0x020 6 355527216 --- Number of Write Commands
0x01 0x028 6 399084711429 --- Logical Sectors Read
0x01 0x030 6 1209208821 --- Number of Read Commands
0x01 0x038 6 2726843900 --- Date and Time TimeStamp
0x03 ===== = = === == Rotating Media Statistics (rev 1) ==
0x03 0x008 4 683 --- Spindle Motor Power-on Hours
0x03 0x010 4 683 --- Head Flying Hours
0x03 0x018 4 44 --- Head Load Events
0x03 0x020 4 0 --- Number of Reallocated Logical Sectors
0x03 0x028 4 0 --- Read Recovery Attempts
0x03 0x030 4 1 --- Number of Mechanical Start Failures
0x04 ===== = = === == General Errors Statistics (rev 1) ==
0x04 0x008 4 0 --- Number of Reported Uncorrectable Errors
0x04 0x010 4 0 --- Resets Between Cmd Acceptance and Completion
0x04 0x018 4 0 --- Physical Element Status Changed
0x05 ===== = = === == Temperature Statistics (rev 1) ==
0x05 0x008 1 35 --- Current Temperature
0x05 0x010 1 33 N-- Average Short Term Temperature
0x05 0x018 1 33 N-- Average Long Term Temperature
0x05 0x020 1 41 --- Highest Temperature
0x05 0x028 1 23 --- Lowest Temperature
0x05 0x030 1 39 N-- Highest Average Short Term Temperature
0x05 0x038 1 25 N-- Lowest Average Short Term Temperature
0x05 0x040 1 35 N-- Highest Average Long Term Temperature
0x05 0x048 1 25 N-- Lowest Average Long Term Temperature
0x05 0x050 4 0 --- Time in Over-Temperature
0x05 0x058 1 60 --- Specified Maximum Operating Temperature
0x05 0x060 4 0 --- Time in Under-Temperature
0x05 0x068 1 0 --- Specified Minimum Operating Temperature
0x06 ===== = = === == Transport Statistics (rev 1) ==
0x06 0x008 4 153 --- Number of Hardware Resets
0x06 0x010 4 17 --- Number of ASR Events
0x06 0x018 4 0 --- Number of Interface CRC Errors
0xff ===== = = === == Vendor Specific Statistics (rev 1) ==
|_ C monitored condition met D supports DSN |_ N normalized value
Pending Defects log (GP Log 0x0c)
No Defects Logged
SATA Phy Event Counters (GP Log 0x11)
ID Size Value Description
0x0001 2 0 Command failed due to ICRC error
0x0002 2 0 R_ERR response for data FIS
0x0003 2 0 R_ERR response for device-to-host data FIS
0x0004 2 0 R_ERR response for host-to-device data FIS
0x0005 2 0 R_ERR response for non-data FIS
0x0006 2 0 R_ERR response for device-to-host non-data FIS
0x0007 2 0 R_ERR response for host-to-device non-data FIS
0x0008 2 0 Device-to-host non-data FIS retries
0x0009 2 5 Transition from drive PhyRdy to drive PhyNRdy
0x000a 2 5 Device-to-host register FISes sent due to a COMRESET
0x000b 2 0 CRC errors within host-to-device FIS
0x000d 2 0 Non-CRC errors within host-to-device FIS
smartctl_-x_output